网站首页 关于步拓 产品世界 新闻动态 资料下载 人才招聘 联系我们
 
管接头编号规则
过渡接头编号规则
胶管及套筒
公制管接头
日制英制管接头
美制管接头
公制过渡接头
日制英制过渡接头
美制过渡接头
混合制过渡接头
测压线及接头
液压系统
manuli液压软管
压力表
过滤器
液压辅件
PARKER高压软管
SUNFLEX工业管
产品世界
当前位置:产品世界 > 胶管及套筒 > 胶管及套筒 > 胶管安装指南
胶管安装指南
 
 产品描述

胶管安装指南

正确地安装胶管至为重要,如胶管过长不但影响外观,而且增加成本。如胶管太短,当其受压而伸展或收缩时,没有足够的伸缩馀地,会引致胶管被破坏。

以下各图显示安装胶管时应注意的事项,依此安装可达致最佳的工作效果并延长胶管寿命。

Hose Installation Guide
Proper hose installation is essential for satisfactory performance.If hose length is excessive the appearance of installation will be unsatisfactory and will cost more. If the hose assembly is too short to permit adequate flexing and changes in length due to expansion or contraction,the hose service life will be feduced.
The following diagrams show proper hose installations which provide mjaximum performance and cost savings.

安装胶管时,切勿让其扭歪,否则当受压时会破坏胶管或令联接处松脱。
When installing hose,make sure it is not twisted,otherwise it will lead to hose failure or loosening of connections.
当安装直管时,应预留松位,使其受压移动时不致被拉紧甚至拉断。
For straight hose,allow enough slack in hose line to provide for length changes occurred when pressure is applied.

当胶管受压时,其长度会改变,因此切勿在弯曲位置加上任何夹子,使其能自由移动。
To allow for length changes when hose is pressurized,do not clamp at bends. Curves will absorb changes.
当弯曲半径太小时,宜采用角弯接头以免胶管出现急弯。
When bend radius is below the required minimum,use angle adapters to avoid sharp bends.

当避免胶管被破坏及流量受限制,胶管弯曲半径应尽可能加大。
To avoid hose collapse and flow restriction,keep hose bend radius as large as pollible.

 
上一个:弹簧护套
 
 

版权所有:北京步拓科贸有限公司 联系方式:电话 010-89203668 手机 13621212891(梁先生) 北京网站建设公司一诺互联  京ICP备15058535号-1
站长统计

我们的工作时间
9:00-18:00
 
在线咨询  在线咨询
咨询电话
    010-89203668
    13621212891